Use a piece of tape and mark the wires (Red1, R2, Blue1, B2). The green wire should be the ground and it should be attached to the outlet box with a grounding screw. When wired correctly, the light should turn on and off at each switch (a switch should not need to be in one position for the other switch to work). without a multimeter (I assume that's the case), the best answer is to use the light to test the connections. I'm including a few references just to help clarify. The red leads on the switch should be paired to blue wires in whichever box you're installing the switch(one red to one blue).Īgain, this is only valid if what I saw in the pictures was correct. Black on the switch is the common, so it should be tied to either the paired blacks in the first box or the orange wire in the second. Here's my take: if it is a feed in/feed out then there should be two white wires tied together in the first box. Both boxes are probably junctioned somewhere, maybe in the attic or the light box itself. Then the box in the first picture is most probably a feed in from the light box(common in older houses), a feed out to the nearest receptacle and the travelers going to the second box. ![]() ![]() ![]() Just looking at the pictures(which are leaving out some needed information) and seeing that these are 4-square boxes, the box in the second picture has the travelers and switch-leg for whatever light is being controlled. Is that correct? Can't tell what the white(s) is(are) connected to, if at all. In the first picture it looks like there are five wires.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |